DSS Pontiac G8 with TH400 Transmission 3.5in Aluminum w/ Direct Fit Rear Flange GMG8SH4-A - 610156

Pontiac G8 + TH400 Transmission 3.5″ Aluminum + Direct Fit Rear Flange

Please Note: Rear Subframe/Cradle Lock-Out kit must be installed on the vehicle prior to installing a Driveshaft Shop 1-Piece Driveshaft. Any damage to the driveshaft, or any subsequent damage caused by failing to properly reinforce the rear cradle and limit movement will void any and all warranty provided by The Driveshaft Shop.

Available now for the G8 (with a TH400 swap ONLY) is our 3.50″ aluminum shaft. We have done extensive testing with stock rears and with our 9″ kit and believe this to the the most cost-effective trouble-free driveshaft for the G8 available today. Comes with grade 12.9 hardware with back up lock nuts to ensure no loose bolts. 1 year warranty. You will have to remove the heat shield from above center hanger mount to install a 3.50″ shaft and there is a possibility of clearance issues with aftermarket exhausts. This is a general warning. We have several test shafts out and not one had an issue. I have listed this because not all exhaust systems have been tested. (We also offer a Carbon fiber shaft is made from 3-3/8 and not the 3-3/4 like other manufacturers)

Special Note: Rear Subframe/Cradle Lock-out kit must be installed on the vehicle prior to installing a Driveshaft Shop 1-Piece Driveshaft. Any damage to the driveshaft (or any subsequent damage) caused by failing to properly reinforce the rear cradle and limit movement will void any and all warranty provided by The Driveshaft Shop.

PART# GMG8SH4-A

Category: 2009-2017 G8 / SS / G8 / SS / Commodore